E BOOT擦除不了
用wince 的e_boot擦除块设备一直是不动像死机一样什麽原因？***TE/OK6410 WINCE SYSTEM FUSING TOOL***
0) IP address: 0.0.0.0
1) Subnet mask: 255.255.255.0
2) DHCP: Disabled
3) Boot delay: 2 seconds
4) Reset to factory default configuration
5) Startup image: LAUNCH EXISTING
6) Program disk image into SmartMedia card: Enabled
7) Program CS8900 MAC address (00:00:00:00:00:00)
8) KITL Configuration: DISABLED
9) Format Boot Media for BinFS
A) Erase All Blocks
B) Mark Bad Block at Reserved Block
C) Clean Boot Option: FALSE
D) Download image now
E) Erase Reserved Block
F) Low-level format the Smart Media card
L) LAUNCH existing Boot Media image
R) Read Configuration
S) DOWNLOAD image now(SDMMC card)
W) Write Configuration Right Now
Enter your selection: a
All block(0) Erase... ++InitializeDisplay()
--InitializeDisplay()
Press to download image stored on boot media, or to enter boot monitor.
Initiating image download in 0 seconds.
Starting auto-download ...
Erasethe block '0..3' 您好，这个错误一般是由SD卡制作错误形成的。请检查您的SD卡，一般6410使用2G（包括）以下的SD卡。并且确认使用的镜像为专门为SD卡启动专用的镜像。
页:
[1]