飞凌2440开发板挂载SD卡时出现错误，请教各位
飞凌2440开发板在挂载SD卡（2G）时出现如下错误：插上SD卡时，超级终端显示：# mmc0: host does not support reading read-only switch. assuming write-enable.
mmcblk0: mmc0:aaaa SD02G 1931264KiB
/dev/mmc/blk0:<3>mmcblk0: error 2 transferring data
end_request: I/O error, dev mmcblk0, sector 0
Buffer I/O error on device mmcblk0, logical block 0
mmcblk0: error 2 transferring data
end_request: I/O error, dev mmcblk0, sector 0
Buffer I/O error on device mmcblk0, logical block 0
unable to read partition table
mmc0: host does not support reading read-only switch. assuming write-enable.
mmcblk0: mmc0:aaaa SD02G 1931264KiB
/dev/mmc/blk0:<3>mmcblk0: error 2 transferring data
end_request: I/O error, dev mmcblk0, sector 0
Buffer I/O error on device mmcblk0, logical block 0
mmcblk0: error 2 transferring data
end_request: I/O error, dev mmcblk0, sector 0
Buffer I/O error on device mmcblk0, logical block 0
unable to read partition table
当输入挂载命令时显示：
# mount -t vfat /dev/mmc/blk0/disc /tmp
mmcblk0: error 2 transferring data
end_request: I/O error, dev mmcblk0, sector 0
FAT: unable to read boot sector
mount: mounting /dev/mmc/blk0/disc on /tmp failed
#
当我换成1G的MMc卡时，插上后，超级终端根本一点反应也没有，在dev目录下没有mmc文件，各位给说说，是怎么回事啊 你用的哪个内核？ 回复 2# 飞凌-alexlee
2.6.18内核的啊，板子自带的，在wince下就能读写操作!
页:
[1]