OK335XS_II的板子以太网phy速度只能达到10M
买的OK335XS_II的开发板，进行网络测试的时候，网络的速度只能达到10M / full.用TFTP进行传输的时候速度很慢，请问下技术人员这是什么现象，按道理来说不应该的楼主，你测试网络速度的时候，是怎么测试的？ 本帖最后由 霹雳游客 于 2014-9-11 12:01 编辑
飞凌-unix 发表于 2014-9-11 08:54 static/image/common/back.gif
楼主，你测试网络速度的时候，是怎么测试的？
从内核的启动信息来看：具体如下：
1.719506] Bluetooth: RFCOMM ver 1.11
[ 1.723427] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 1.728961] Bluetooth: BNEP filters: protocol multicast
[ 1.734418] Bluetooth: HIDP (Human Inte**ce Emulation) ver 1.2
[ 1.741026] Registering the dns_resolver key type
[ 1.746041] VFP support v0.3: implementor 41 architecture 3 part 30 variant c rev 3
[ 1.754056] ThumbEE CPU extension supported.
[ 1.758570] mux: Failed to setup hwmod io irq -22
[ 1.764188] Power Management for AM33XX family
[ 1.769049] Trying to load am335x-pm-firmware.bin (60 secs timeout)
[ 1.775740] Copied the M3 firmware to UMEM
[ 1.780100] Cortex M3 Firmware Version = 0x181
[ 1.793127] clock: disabling unused clocks to save power
[ 1.800940] Detected MACID=d0:39:72:17:b6:60
[ 1.806695] cpsw: Detected MACID = d0:39:72:17:b6:62
[ 1.816884] input: gpio-keys as /devices/platform/gpio-keys/input/input1
[ 1.825718] rtc-ds1307 2-0068: setting system clock to 2014-07-14 21:27:43 UTC (1405373263)
[ 1.838787] net eth0: CPSW phy found : id is : 0x20005c90
[ 1.912784] mmc0: host does not support reading read-only switch. assuming write-enable.
[ 1.923751] mmc0: new high speed SDHC card at address 1234
[ 1.930110] mmcblk0: mmc0:1234 SA04G 3.63 GiB
[ 1.937236]mmcblk0: p1 p2
[ 3.832530] PHY: 0:00 - Link is Up - 10/Full
最后一行显示的是PHY: 0:00 - Link is Up - 10/Full显示的10M 楼上朋友，您的板卡是直接连接到100M交换机上面的吗？这样的现象出现的很特别，我们这边都是100M的板卡：
INIT: Entering runlevel: 5
Starting system message bus: dbus.
Starting telnet daemon.
Starting inetd daemon.
Starting syslogd/klogd: done
2000-01-01 00:00:26: (log.c.166) server started
Stopping Bootlog daemon: bootlogd.
[ 12.342884] PHY: 0:00 - Link is Up - 100/Full
_____ _____ _____ _ _ __ ___ __
|___| /_ |_ | | | | | | | / /
| |__ | | | | | |_| || | | | | | | / /
|__|| | | | |_/| | | | | | | }{
| | | |_| | | | | |___| | | | |/ /
|_| _____/ |_|_ |_____| |_| |_|_| /_/_
ok335x login:
本帖最后由 飞凌-develop 于 2014-9-11 15:43 编辑
10M网络的现象还是很特别的，换一个网络环境试试看。如果还是有问题更新到我们最新升级镜像2014-09-10版本，再试试看。 飞凌-develop 发表于 2014-9-11 15:39 static/image/common/back.gif
10M网络的现象还是很特别的，换一个网络环境试试看。如果还是有问题更新到我们最新升级镜像2014-09-10版本， ...
我是直接连在电脑上的
页:
[1]